Hara Metals
Service Area
We are a Kingston, Oklahoma shop on the north side of Lake Texoma. We take marine and fabrication jobs around Texoma and into North Texas. Drive times below are typical; traffic and the exact job site will change them.
How far we run
Based in Kingston, close to Texoma
The shop is at 6 North Kemp Street, Kingston, OK 73439. From here we head south across the lake country into Grayson County, and we also work west and east in southern Oklahoma.
Denison is typically about a 45-minute drive and Sherman about 50–55 minutes, by way of US-70 and US-75 / US-69. Madill is usually about 10–15 minutes. Durant is typically about 30 minutes, and Ardmore about 45 minutes. North Dallas suburbs such as McKinney, Frisco, and Prosper are generally about an hour and 20 minutes; Denton is usually about an hour and a half, depending on the route and traffic.
Oklahoma
- Kingston (shop)
- Madill
- Ardmore
- Durant
- Marshall, Bryan, and Carter Counties
Texas & Lake Texoma
- Lake Texoma shoreline, both sides
- Denison
- Sherman
- Grayson County
- McKinney, Frisco, Prosper, and Denton
If your job is a little farther out, call anyway. We will tell you whether we can take it.